IGNITION COIL INSPECTION

BHE011801009W03

Ignition Coil With Built-in Power Switch Inspection

1. Disconnect the ignition coil connector.

2. Measure the resistance between each terminal on the ignition coil connector.

• If the measurement corresponds to the table, replace the ignition coil.


Item	Tester Connection Position		Condition
Item	Positive	Negative	Condition
Terminal	A	B	∞ or 0 ohm is abnormal
	B	C	∞ or 0 ohm is abnormal
	C	A	0 to several kilohm (continuity) is abnormal