DTC C1306

BHE040243000W30

DTC

C1306

Steering angle sensor (abnormal initialization)

DETECTION CONDITION

• The steering angle sensor detects that the initialization procedure has not been performed.

POSSIBLE CAUSE

• The initialization procedure for the steering angle sensor has not been performed.
• Steering angle sensor malfunction
• The negative battery cable connector was disconnected previously.

Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY OTHER DTC HAS BEEN RECORDED

• Has DTC C2778 also been stored?
Yes
Go to the applicable DTC inspection.
(See DTC Table.)
No
Go to the next step.
2

VERIFY INITIALIZATION PROCEDURE.

• Has the steering angle sensor initialization procedure been performed?
Yes
Go to the next step.
No
Perform the steering angle sensor initialization procedure, then go to the next step. (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE.)
3

VERIFY DTC TROUBLESHOOTING COMPLETED

• Clear the DTC from the memory.
• Is the same DTC present?
Yes
Repeat the inspection from Step 1.
If the malfunction occurs again, replace the steering angle sensor.
No
Go to the next step.
4

VERIFY AFTER REPAIR PROCEDURE

• Are any other DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC Table.)
No
DTC troubleshooting completed.